Department of ECE

Dr. Madhusudhana Reddy Barusu – Overview

Qualifications

  • Ph.D in Signal Processing from Anna University, Chennai in 2020
  • M.Tech from Sathyabama University, Chennai in 2009
  • B.Tech from Narayana Engineering College in 2007

Subjects Taught

  1. Electronic Devices and Circuits
  2. Digital Logic Design
  3. Signals and Systems
  4. VLSI Design
  5. Digital Signal Processing

Publications and Achievements

Journals

  • Presented a paper in IEEE Sensors Journal, “Non-invasive Vibration Measurement for Diagnosis of Bearing Faults in 3-Phase Squirrel Cage Induction Motor Using Microwave Sensor”. vol. 21, no. 2, pp. 1026-1039, 15 Jan, 2021
  • Presented a paper in IETE Journal of Research, “Diagnosis of Multiple Rotor Bar Faults of Squirrel Cage Induction Motor (SCIM) Using Rational Dilation Wavelet Transforms”. (SCI-E Indexed, IF-1.125) DOI:10.1080/03772063.2020.1816223
  • Presented a paper in Elektronika ir Elektrotechnika, “Diagnosis of Bearing Outer Race Faults Using a low-cost non-contact method with Advanced Wavelet Transforms”. Volume 25, Issue 1, February 2019, p.44-53 (SCI-E Indexed, IF-1.08) DOI: 10.5755/j01.eie.25.1.22735
  • Presented a paper in IET Power Electronics, “Low-Cost SPLL Based Electrical Faults Identification for Three-Phase Squirrel Cage Induction Motor Using Handheld Doppler RADAR Signal Analysis”. Volume 11, Issue 7, June 2018, p. 1205 – 1216 (SCI-E Indexed, IF- 2.839) DOI: 10.1049/iet-pel.2017.0267
  • Presented a paper in IET – The Journal of Engineering. “A non-invasive method for rotor bar fault diagnosis in three-phase squirrel cage induction motor with advanced signal processing technique”. Vol. 2019 Iss. 17, pp. 4415-4419 – (ESCI-Indexed) DOI: 10.1049/joe.2018.8242
  • Presented a paper in International Journal of All Research Education and Scientific Methods (IJARESM), “Comparative Analysis of Wallace Tree Multiplier With Fast Adders Using Xilinx ISE”. ISSN: 2455-6211 Volume 8, Issue 11, pp: 20-27, November-2020, (UGC Indexed-ISSN: 2455-6211)
  • Presented a paper in International Journal of All Research Education and Scientific Methods (IJARESM), “Realization of Different High-Speed Adders Using Quantum-Dot Cellular Automata (QCA) – A Review”. ISSN: 2455-6211 Volume 8, Issue 11, pp: 65-72, November-2020, (UGC Indexed-ISSN: 2455-6211)
  • Presented a paper in JXAT – “Design of switched capacitor based ring modulator using differential voltage current conveyor and Op-Amp 180-90 nm technology”, Volume XII, Issue IV, April-2020, pp. 3051-3063. (Scopus Indexed) DOI: 10.37896/JXAT12.04/1043
  • Presented a paper in International Journal of Mechanical and Production Engineering Research and Development (IJMPERD)– “Irrigation, fertilizing and weed cutting in the row crops with IOT controlled robot” – ISSN (P): 2249-6890; ISSN (E): 2249-8001, Vol. 8, Special Issue 3, Dec 2018, pp.512-518 (Scopus Indexed)
  • Presented a paper in International Journal of Pure and Applied Mathematics: “Bronchogenic carcinoma identification with X-ray image using fuzzy C means” – Volume 119 No. 15, Pg.No. 727-730, ISSN: 1314-3395, 2018. (Scopus Indexed)
  • Presented a paper in International Journal of Pure and Applied Mathematics “comparative analysis of eye detection and tracking algorithms for Surveillance” Volume 117 No. 22, Pg.No. 71-75, ISSN: 1314-3395, Dec’2017. (Scopus Indexed)
  • Presented a paper in International Journal of Applied Engineering Research “CMOS Based Digital Controlled Oscillators (DCO)–A Review” ISSN 0973-4562 Vol. 10 No.20, 2015, pgno:18726-18730. (Scopus Indexed)
  • Presented a paper in Journal of Theoretical and Applied Information Technology “Error Compensated Fixed Width Modified Booth Multiplier for Multimedia Applications” 31st December 2014. Vol.70 No.3, Pg No: 451-458. (Scopus Indexed)
  • Presented a paper in IOSR Journal of Electronics and Communication Engineering “Restoration of Images Corrupted by High-Density Salt & Pepper Noise through Adaptive Median Based Modified Mean Filter” e-ISSN: 2278-2834, p-ISSN: 2278-8735. Volume 5, Issue 5 (Mar. – Apr. 2013), PP 11-15.

Conferences

  • Presented a paper in 2nd IEEE International Conference for Innovation in Technology (INOCON), Bangalore, India on “Optimal Utilization of Water for Smart Farming Using Internet of Things (IoT)”, conducted on Mar 3-5, 2023
  • Presented a paper in 1st AICTE – International Conference-Advances in Mechanical Engineering ICAME’21, Chennai, India on “A survey on advantages and disadvantages, applications of electromagnetic damping”, conducted on Jan 27-28, 2021
  • Presented a paper in AICTE – National Conference on Technology for Impactful and Sustainable Development of the Society (TISDS-2020), Kurnool, India on “Improved Wireless EEG Based Emergency Braking System”, Dec 15-16, 2020
  • Presented a paper in 1st IETE – International Conference-ICRTST-2020, Mysuru, India, on “Simultaneous Diagnose of Bearing and Rotor Bar Faults of Induction Motor Using Doppler UWB RADAR Signal Analysis”, conducted on Jun 17-18, 2020
  • Presented a paper in 22nd IEEE International Conference ELECTRONICS-2018, Palanga, Lithuania, on “Diagnosis of Bearing Outer Race Faults Using a low-cost non-contact method with Advanced Wavelet Transforms”, conducted on Jun 18-20, 2018
  • Presented a paper in 9th IET International Conference on Power Electronics, Machines and Drives (PEMD-2018), Liverpool, United Kingdom, on “A non-invasive method for rotor bar fault diagnosis in three-phase squirrel cage induction motor with advanced signal processing technique”, conducted on Apr 17-19, 2018